neoOBD 2 PRO

Device Specifications

Low power consumption
Power supply: 4.5-40V operation
Four full-color status LEDs
Temperature range: -40°C to +85°C
Vehicle connectors: 16-pin OBD 2 male and 16-pin OBD 2 female
One-year limited warranty
Field-upgradeable flash firmware
Microsoft-certified USB drivers
USB Type-C Host for neoVI MIC GPS or powering accessories like a Raspberry PI drawing up to 3A at 5V
High speed (480 Mbits/sec) USB interface
Standalone mode support, including scripting, receive messages, transmit messages, expressions, I/O and transport layers
J2534 and RP1210 A/B compatible for CAN/ISO15765-2:2016 (CAN FD)
On-board 64 MB flash storage
Battery-backed real time clock (RTC)

Timing Specifications

64-bit timestamping to an accuracy of 25 nanoseconds on CAN FD networks and 10 microseconds on LIN networks with no overflow
Accuracy of 0.5 microseconds possible if using only one network
Simultaneous operation on all CAN/LIN networks
Transmit message double-buffering on all networks, allowing back-to-back message transmission

Network Specifications – CAN

4x ISO CAN FD channels implemented using the industry standard Bosch MCAN CAN FD core
CAN 2.0B compatible for all CAN networks
4 dedicated ISO11898 Dual Wire CAN FD physical layers (MCP2562FD)
1 dedicated Single Wire CAN physical layer GMW3089 / SAEJ2411 (MC33897)
Up to 1 Mb/s software-selectable baud rate for arbitration phase (auto baud capable)
Up to 8 Mb/s software-selectable baud rate for data phase (auto baud capable)
Listen-only mode support
Single Wire High Speed Mode, Test Tool Resistor, and High Voltage Wakeup support

Network Specifications – LIN, ISO9141, Keyword 2000 or K and L Line

2x LIN (Local Interconnect Network)
Full support for LIN 1.X, 2.X and J2602
LIN J2602 / 2.X compatible physical layer
Software-enabled 1K LIN Master Resistor per channel
LIN Bus Monitor Mode identifies errors: Sync Break Error State and Length, Sync Wave Error, Message ID parity, TFrameMax/Slave Not Responding, Checksum Error and Transmit Bit Errors
LIN Bus Master Mode operates at same time as LIN Bus Monitor
LIN Bus Slave simulation, with or without an LDF file
LIN Bus hardware schedule table with support for LIN diagnostics
Initialization Waveforms, including Fast Init, Five Baud, and Custom
Software-selectable baud rate

Network Specifications – DoIP / XCP / Automotive Ethernet

10/100 Ethernet PHY with low-power mode
Compatible with 100BASE-T1 / BroadR-Reach® using Intrepid RAD-Moon media converter accessory
Software-controlled DoIP activation line

* 상세 규격은 변경될 수 있습니다. 구매 전 최신 상세 규격을 확인 바랍니다.